All Title
Guangzhou One-Stop Engineering Plastics Industries (group) Co., Ltd
Home> News> Analysis and solution of common problems in blowing film (9(injection molding products)
December 09, 2023

Analysis and solution of common problems in blowing film (9(injection molding products)

9, the film longitudinal tensile strength is poor

Reason 1: The temperature of the molten resin is too high, which will reduce the longitudinal tensile strength of the film;

Reason 2: The blowing ratio is too large and does not match the traction ratio, so that the transverse orientation and tensile strength of the film are increased, and the longitudinal tensile strength will become worse;

Reason 3: The traction speed is slow, and the longitudinal orientation of the film is not enough, so that the longitudinal tensile strength becomes worse.

Reason 4: The cooling speed of the film is too fast;

solution
① Appropriately reduce the temperature of the molten resin;

② Increase the traction speed appropriately;

(3) Adjust the blowing ratio to adapt to the traction ratio;

④ Reduce the cooling speed appropriately.
Previous
Next
Share to:

LET'S GET IN TOUCH

About Us

Related Products List

Contact Us

Send Inquiry

Copyright © 2024 Guangzhou One-Stop Engineering Plastics Industries (group) Co., Ltd All rights reserved. Privacy Policy

Please Leave Us A Message

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Upload Attachment
Send